CCG Cable Glands - Contact us via email
Why use CCG?
- Industrial
Junction Boxes
- Industrial
    3-Way Bottom Entry™ Box   images/products/thispagearrow.jpg
    Foundation Box   images/products/thispagearrow.jpg
    Handi Fit™ 4-Way Box   images/products/thispagearrow.jpg
    Handi Fit™ H Box   images/products/thispagearrow.jpg
    Handi Fit™ Y Box   images/products/thispagearrow.jpg
    Newcastle Box   images/products/thispagearrow.jpg
    Roof Box   images/products/thispagearrow.jpg
    Utility™ Box   images/products/thispagearrow.jpg
Technical Info
Contact Us









Mining and Industrial Boxes

CCG Handi Fit™ H Box IP66/67/68

   for Industrial, Commerical and Mining Electrical Installations
Features and Benefits
  • Internal earth continuity ring and earth studs provided.
  • DIN Rail mounting studs are provided for use with terminal blocks. 
  • Raised domed lid facilitates connections to be made outside of the box.
  • Only approved CCG cable glands and terminals must be used.
  • Dust and water tight to IP68 when fitted with CCG sealed cable glands.
  • Boxes can be buried for extended periods.
  • Boxes with see through polycarbonate “adapt-a-lids” available on request.
  • 4-Way H-Boxes with parallel entries available on request.
  • Red Fire Rated Box for emergency circuits available (925°C for 3-hours).
Wiring and Installation instructions for IP rated CCG Junction Boxes.

  • Installation must be carried out by a competent person.
  • Do not install under live current conditions.
  • The box must not be modified in any way, as this will invalidate the certification.
  • All wiring must be carried out in accordance with the relevant Codes of Practice.
  • The wiring insulation must not extend by more than 1.0mm from the metal face of the terminal.
  • The voltage and current value of the box must not be exceeded. 
  • See relevant certificate for current limitations for conditions of use / schedule of limitations.
  • Only those terminals shown in the terminal schedule may be incorporated in the box.
  • Inner cable bedding must protrude into the box by a minimum of 20mm past the cable entry point.
  • Not more than one single or multiple strand lead shall be connected into either side of the terminals.
  • Only earth conductors of equal size shall be connected with rail mounted terminals.
  • All terminal screws used and unused shall be tightened.
  • A parallel shaft screw driver of the correct size should be used for rail mounted terminals screws.
  • Where cables enter the box they must be secured by CCG Cable Glands appropriate to the make up of the cable. 
  • Unused entry apertures must be blanked with certified CCG Blanking Plugs.
  • To maintain IP66/68 a thread seal gasket between the box and cable gland must be installed.
  • Before replacing the lid, ensure the lid gasket is in place.
  • The use of a CCG Box Spanner (Lid Locking Key) is required to maintain the tamper proof integrity of the box.

Technical Data
Download PDF

Download CML 17Y11251
Download MASC 12-145
Home | Products | Search | Technical Info | News | Contact us |
All content copyright © 2004 - 2008  CCG Cable Terminations Pty Ltd

33/37 Forge Road - Spartan - Gauteng - South Africa
P O Box 192 - Kempton Park - 1620 - Gauteng - South Africa
Tel: +27 11 394-2021   Fax: +27 11 975-5825    Email: